Carbon deposit cleaning agent for heat transfer oil pipeline

The heat transfer oil will undergo physical and chemical changes under the action of temperature and oxygen, and with the increase of time and temperature, the change process will accelerate. The operating temperature of the heat transfer oil should generally be below 300℃. The temperature has a great influence on the oxidation speed and products of the heat transfer oil. Serious carbon deposits and coking are produced on the inner wall of the heat transfer oil pipeline, which ultimately affects the service life of the heat transfer oil.

AJ-2-121 thermal oil pipeline carbon deposit cleaning agent has excellent permeability, emulsification and oil coke removal ability. It quickly penetrates to the bottom of the carbon deposit through chemical action, dissolving, dispersing and stripping In addition to all kinds of hard grease and carbon deposits, whether it is a thin layer of carbon deposit or a thick layer of carbon deposits, it can fall off and dissolve within 4-6 hours. The effect is extremely significant, and it is safe and non-corrosive. It is currently the best product for professional carbon removal.

Product features: (This product has a solvent odor, colorless and transparent liquid, specific gravity: 1.15±0.05, non-burning.)
1. Safety: non-toxic, non-corrosive and non-flammable.
2. It is easy to use, without heating and mechanical stirring.
3. Economy: It can be used repeatedly.

4. Non-combustible, non-explosive, non-toxic and harmless, as well as fast dissolution rate and low volatilization rate are the typical features of this product.

5. The speed of dissolving coke is much higher than that of similar products, and the speed of volatilization is much lower than that of similar products.
Scope of application:
Removing grease and carbon deposits in hot oil furnaces, pipelines, and heat transfer oil systems.
How to use:
1. Drain the remaining heat transfer oil from the system
2. After adding the AJ-2-121 heat transfer oil pipeline the carbon deposit cleaning agent into the heat transfer oil system, cycle cleaning for 2-4 hours, and then discharge the cleaning waste liquid. If the carbon layer exceeds 4-5 mm, the soaking and cycle cleaning time can be extended to 4-6 hours. Note that when discharging, be sure to maintain a certain pressure in the system so that the fallen carbon deposits can be discharged smoothly and avoid clogging the pipeline.
3. Use this productAfter cleaning, there is no need to rinse with water. After the surface is dry, directly add heat transfer oil to start the machine.

If you have product needs and questions, please call Hebei Aijieneng Cleaning Service Co., Ltd. to obtain a cleaning plan and quotation. aijienengjyw